Installation - G-U BKS C-S P 100 Installationsanleitung

Installation Instructions
Access Control Unit C-S P 100, C-S A 100
5

Installation

The electrical connection may only be carried out by trained personnel and must be
performed in compliance with the particular national regulations.
Take the control unit from the packing.
Attach the mounting plate on a smooth surface using the sheet metal screws or the M3
screws enclosed. Drill a hole at centre for the connecting cable.
Before finally mounting the control unit, you should connect the wires and verify its proper
functioning. Put 4 O-rings on the snap-on fixtures and 1 O-ring on the plug for the sabotage
contact. Press the control unit on the mounting plate ensuring that it snaps into place
correctly.
Installation Instructions, Edition B dated 23/06/2010
Copyright © G-U GmbH, 2010. All rights reserved.
Page 30 of 48
C 59 501 132