Werbung
English
Safety instructions
DANGER
Risk of electric shock. All cables shall be de-energized
before installing or performing maintenance on the
product.
WARNING
The Axis product shall be installed by an authorized
electrician, and in compliance with local laws and
regulations.
WARNING
The Axis product shall be installed by a trained
professional, and in compliance with local laws and
regulations.
CAUTION
Moving parts. Risk of injury. Keep your body
parts away from the product when it's in operation.
Disconnect from power supply before installing or
performing maintenance on the product.
CAUTION
Hot surface. Risk of injury. Don't touch the
product when it's in operation. Disconnect from
power supply and allow the surfaces to cool before
performing maintenance on the product.
NO TICE
TICE
NO
NO
TICE
•
The Axis product shall be used in compliance with
local laws and regulations.
•
Store the Axis product in a dry and ventilated
environment.
•
Avoid exposing the Axis product to shocks or heavy
pressure.
•
Do not install the product on unstable poles,
brackets, surfaces or walls.
•
Use only applicable tools when installing the Axis
product. Using excessive force with power tools
could cause damage to the product.
•
Do not use chemicals, caustic agents, or aerosol
cleaners.
•
Use a clean cloth dampened with pure water for
cleaning.
•
Use only accessories that comply with the technical
specification of your product. These can be provided
by Axis or a third party. Axis recommends using
Axis power source equipment compatible with your
product.
•
Use only spare parts provided by or recommended
by Axis.
•
Do not attempt to repair the product yourself.
Contact Axis support or your Axis reseller for
service matters.
•
Use a yellow/green colored grounding cable of at
2
least 0.5 mm
or 20 AWG.
Transportation
NO TICE
TICE
NO
NO
TICE
•
When transporting the Axis product, use the
original packaging or equivalent to prevent damage
to the product.
Battery
The Axis product uses a 3.0 V BR2032 lithium battery
as the power supply for its internal real-time clock
(RTC). Under normal conditions this battery will last
for a minimum of five years.
Low battery power affects the operation of the RTC,
causing it to reset at every power-up. When the
battery voltage is low, a log message will appear in
the product's server report.
CAUTION
Do not replace the battery yourself. Contact Axis
support if the log message requests a battery change.
Lithium coin cell 3.0 V batteries contain
1,2-dimethoxyethane; ethylene glycol dimethyl ether
(EGDME), CAS no. 110-71-4.
Dome cover
NO TICE
TICE
NO
NO
TICE
•
Be careful not to scratch, damage or leave
fingerprints on the dome cover because this could
decrease image quality. If possible, keep the
protective plastic on the dome cover until the
installation is complete.
•
Do not clean a dome cover that looks clean to
the eye and never polish the surface. Excessive
cleaning could damage the surface.
•
For general cleaning of the dome cover it is
recommended to use a non-abrasive, solvent-free
neutral soap or detergent mixed with pure water
and a soft, clean cloth. Rinse well with pure
lukewarm water. Dry with a soft, clean cloth to
prevent water spotting.
•
Never use harsh detergents, gasoline, benzene,
acetone, or similar chemicals.
•
Avoid cleaning the dome cover in direct sunlight or
at elevated temperatures.
Français
Consignes de sécurité
DANGER
Risque de choc électrique. Tous les câbles doivent
être mis hors tension avant l'installation ou une
intervention de maintenance sur le produit.
AVERTISSEMENT
Le produit Axis doit être installé par un électricien
agréé et conformément aux lois et règlementations
locales en vigueur.
AVERTISSEMENT
Le produit Axis doit être installé par un professionnel
qualifié et conformément aux lois et règlementations
locales en vigueur.
ATTENTION
Pièces mobiles. Risque de blessure. Restez
à l'écart du produit lorsqu'il est fonctionnement.
Débranchez l'alimentation électrique avant d'installer
le produit ou d'effectuer son entretien.
Werbung
