Technoline WT 8995 Bedienungsanleitung Seite 2

WT 8995 - RADIO CONTROLLED WALL CLOCK
Instruction manual
Set up
Insert a 1,5V Alkaline AA, LR06 battery, ensuring that you have it the correct way round. The clock sets itself automatically to 4, 8 or 12
o'clock and then starts to search for a radio signal. Once the DCF time signal has been received and processed (max.2 minutes) the clock
automatically goes to the correct time. You should not move the clock to a different position during this reception set-up process. If the clock
fails to establish a good reception, it stays as it is and after 2 hours starts to search for a signal again. In this case, you should choose a
different location for the time-setting process. Before you do this, remove the battery for about a minute and then insert it into the battery
compartment again.
Hereby, Technotrade declares that this product WT8995 is in compliance with the essential requirements and other relevant provisions of
Directive 2014/53/EU and ROHS 2011/65/EC. The original EU declaration of conformity may be found at:
www.technoline.de/doc/4029665089959
Environmental reception effects
The clock obtains the accurate time with wireless technology. Same as all wireless devices, the reception is maybe affected by the following
circumstances:

long transmitting distance

nearby mountains and valleys

near freeway, railway, airports, high voltage cable etc.

near construction site

among tall buildings

inside concrete buildings
 near electrical appliances (computers, TV's, etc) and metallic structures

inside moving vehicles
Place the clock at a location with optimal signal, i.e. close to a window and away from metal surfaces or electrical appliances.
Precautions

This main unit is intended to be used only indoors.

Do not subject the unit to excessive force or shock.

Do not expose the unit to extreme temperatures, direct sunlight, dust or humidity.

Do not immerse in water.

Avoid contact with any corrosive materials.

Do not dispose this unit in a fire as it may explode.

Do not open the inner back case or tamper with any components of this unit.
Batteries safety warnings

Use only alkaline batteries, not rechargeable batteries.

Install batteries correctly by matching the polarities (+/-).

Always replace a complete set of batteries.

Never mix used and new batteries.

Remove exhausted batteries immediately.

Remove batteries when not in use.

Do not recharge and do not dispose of batteries in fire as the batteries may explode.

Ensure batteries are stored away from metal objects as contact may cause a short circuit.

Avoid exposing batteries to extreme temperature or humidity or direct sunlight.

Keep all batteries out of reach from children. They are a choking hazard.
Use the product only for its intended purpose!
Consideration of duty according to the battery law
Old batteries do not belong to domestic waste because they could cause damages of health and environment. You can
return used batteries free of charge to your dealer and collection points. As end-user you are committed by law to bring
back needed batteries to distributors and other collecting points!
Consideration of duty according to the law of electrical devices
This symbol means that you must dispose of electrical devices separated from the General household waste when it
reaches the end of its useful life. Take your unit to your local waste collection point or recycling centre. This applies to all
countries of the European Union, and to other European countries with a separate waste collection system.