Set To 220V If Used In Europe - E-Lektron BB651184 Bedienungsanleitung

SET TO 220V IF USED IN EUROPE

The switch can be changed by inserting a screwdriver into the slot and thus moving the switch. This
process protects against accidental changeover during operation.
ATTENTION: if the switch is set incorrectly, you can damage the voltage converter AND 110V device.
POWER
The maximum power of the voltage converter is also the continuous power. As soon as this power is
exceeded, the device fuse of the converter will blow to protect the voltage transformer.
The power of the voltage converter should always be above the maximum power requirement of
your 110V device. The nominal power of your 110V device can be found on the identification plate of
your device. You can run several 110V devices on the converter as long as the total power of the
110V devices does not exceed the converter power.
As far as your 110V unit is equipped with an electric motor, the starting current of the motor will be
above nominal power as indicated on the identification plate. If the starting current is not known,
please calculate with a starting current of 2-3x the nominal power.