EDIFIER Xemal X2s Bedienungsanleitung

Tru e Wi rel es s Earbuds Head ph o nes
EN 1. Power ON/OFF
White LED lit for 1s
1. Power ON when taken out of the case.
2. Power OFF when placed in the case.
Note:
If there is no Bluetooth connection for 10 minutes after powered on,
the earbuds will power off automatically.
2. Pairing
Indicator
1st Pairing
1. Taken out of the case. White and blue LEDs will blink alternately.
2. Select "EDIFIER X2s" in your Bluetooth device setting to connect.
White LED will blink twice in 5 seconds when successfully.
Note:
For subsequent use, the earbuds will automatically connect to the
device used last time.
3. Reset
8s
Indicator
1. Taken out of the case.
2. Disconnected from any Bluetooth device. Press and hold the touch
panel on either earbud for around 8s until blue LED blinks 6 times
to clear the Bluetooth pairing records and power off. If the left and
right earbuds are connected, the other side will clear the
Bluetooth pairing record and power off too.
3. Placed back in the case and taken out of the case again.
4. Select "EDIFIER X2s" in your Bluetooth device setting to connect.
White LED will blink twice in 5 seconds when successfully.
4. Left & Right connection
x5
Indicator
1. When earbuds are powered on and there is no Bluetooth connection
and TWS connection, respectively tap the touch panel 5 times on
both earbuds until white LED blinks slowly to enter TWS pairing
mode. Once the left and right earbuds are connected successfully,
white and blue LEDs will blink alternately to enter Bluetooth
pairing mode.
2. Select "EDIFIER X2s" in your Bluetooth device setting to connect.
White LED will blink twice in 5 seconds when successfully.
5. Charging
Indicator
6. Controls
Left Touch Panel
Note:
1. Images are for illustrative purposes only and may differ from the
actual product.
2. Download Edifier Connect App for more customizable control
settings.
For more information, please visit our website:
@Edifierglobal
Model: EDF200123
Edifier International Limited
P.O. Box 6264
General Post Office
Hong Kong
www.edifier.com
2023 Edifier International Limited. All rights reserved.
Printed in China
NOTICE:
For the need of technical improvement and system upgrade,
information contained herein may be subject to change from time
to time without prior notice.
Products of EDIFIER will be customized for different applications.
Pictures and illustrations shown on this manual may be slightly
different from actual product. If any difference is found, the actual
product prevails.
X 2 s
Manual
Earbuds
1. When hearing a low battery prompt tone, please
place the earbuds in the case for charging.
2. White LED on earbud is steady lit when charging
and off when fully charged.
Charging Case
1. Please connect the case to power source with
the included Type-C charging cable for charging.
2. White LED is steady lit when charging and off
when fully charged.
Note:
Please do not charge the earbuds when there is
sweat or other liquids inside the charging port,
which may damage the earbuds.
Input: 5V 200mA(Earbuds)
5V 1A(Charging case)
2s
x2
x3
x2
x2
2s
www.edifier.com
@Edifier_Global
Indicator
Indicator
Indicator
Right Touch Panel
2s
x2
x3
x2
x2
2s
@Edifier_Global
8s
x5