Blaupunkt GRS901 Bedienungsanleitung Seite 7

GRS901
1. Lid
2. Handle
3. Control panel
a) display
b) heater selection buttons: top+bottom,
top only, bottom only
c) START button
d) CANCEL button
e) temperature and time control knob
BEFORE FIRST USE
1. Remove all the cardboards, papers, foils which secure the appliance and it's parts.
It is recommended to turn on the device first to „burn it out". Keep the appliance operate for few
minutes to get rid of manufacturing odour. Device could emit some smoke. That's normal.
2. Clean the device with suggestion mentioned in chapter CLEANING AND MAINTENECE.
REMOVABLE PLATES
To remove the plates, release the locked latches blocking heating plates and remove the plates. To
insert plates, embed plate into catches and then press it to snap blocked the plate.
USING THE APPLIANCE – GRILL
Prepare the ingredients required.
Choose the type of hot plates (plain or ribbed) to use and place them in the appliance. Make sure that
the drip tray has been correctly slid in position.
Connect the appliance to the power source. The grill will be on standby and display the "OFF" symbol.
Select the heating mode: upper grill, lower grill, both grill.
Use the knob to set the desired temperature and grilling time. Turn the knob to change the parameter
value and press the knob button to change over the parameter.
Press the START button to start heating. The appliance will start to heat up to the expected
temperature, the display will indicate the heating phase by displaying the "PRE" symbol.
When the grill reaches the desired temperature an alarm will sound and the values on the display will
be flashing. Put the ingredients to the hot plates and press the START button (if the START button is not
pressed for 30 minutes, the grill will change to sleep mode and display "OFF"). After pressing the START
button, the grill will keep the selected temperature and count down the time to the end.
When the selected time has elapsed, the grill will beep and the display show "done".
Press the CANCEL button to switch the grill off earlier.
After grilling, remove the plug from the mains socket and allow the appliance to cool down.
The grill can work as an open grill with the top lid raised by 180 degrees. The food is grilled on one side
only, while you can close the top lid to increase the grilling area.
USING THE APPLIANCE – WAFFLE MAKER
Prepare your waffle dough. See further section in this manual for sample recipes.
Place the waffle plates in the appliance.
Connect the appliance to the power source. The appliance will be on standby and display the "OFF"
symbol.
Select the heating elements: both grill.
Use the knob to set the desired temperature and baking time. Turn the knob to change the parameter
value and press the knob button to change over the parameter.
The recommended setting is 210 degrees and 5 minutes. The choice of parameters depends largely on
the prepared dough
Press the START button to start heating. The appliance will start to heat up to the expected
temperature, the display will indicate the heating phase by displaying the "PRE" symbol.
When the appliance reaches the desired temperature an alarm will sound and the values on the display
will be flashing. Pour the dough over the grooved hot plate (about 4 x 80 ml), and close the lid. Press
the START button. After pressing the button, the appliance will keep the selected temperature and
count down the time to the end.
4. Hot plates:
a) dual side for grilling
b) for waffles
5. Hot plate latches
6. Slide-out drip tray
5