yeep.me 100c signature Bedienungsanleitung Seite 12

CONTROLS:
EN
1.
• There is 4 lights modes : 2.
Mode 0 = all OFF
Mode 1 = front LED light (2) only
Mode 2 = mode 1 + headlight (1) & rear light
Mode 3 = mode 2 + deck lights
• To activate, desactivate or change the lights modes, shortly press the button on the
right handle (18).
• To turn the device on and off: use the starter key provided with the unit. The device
turns off automatically after 180 seconds of inactivity.
• To change the device's speed mode: briefly press the speed change button (19).
• To activate the hazard emergency lights, long press the left turn signal button (16).
SPEED MODES:
There are 3 speed modes :
• Mode 1, PEDESTRIAN mode, limited to 6 km/h.
• Mode 2, ECO mode, limited to 15 km/h.
• Mode 3, SPORT mode, limited to 25 km/h.
Information: In order to drive safely and in compliance with local regulations, you
must adjust your speed using the mode indicators.
When using mode 1, your speed will be limited to 6 km/h (maximum speed allowed on
pavements in some cities. It is the user's responsibility to check local regulations.)
Mode 2 allows you to limit the speed to 15 km/h.
Mode 3 allows you to ride up to 25 km/h depending on your weight. You can also
check your speed using additional equipment such as a smartphone or other device.
3.2. UNPACKING AND ASSEMBLING THE DEVICE
To unpack the product, it is recommended to have a clear surface that is large enough
to unpack and prepare the device. Take the device out of its packaging, making sure
to not injure yourself or damage other products or your surroundings. Have someone
help you if the product is too heavy for you to handle on your own (the weight of the
device is indicated on the packaging).
Before using the product, the handles must be assembled. To do this, unfold the
device (see following sections) and install the brake lever and the handles as per the
following instructions:
An adult must unpack and assemble the device.
1. Before screwing on the handles, install the braking lever on the left-hand side and
adjust the position of the brake lever by screwing it on once the handles have been
installed.
2. Use the markings on the handles to help you. R marks the right-hand handle and L
12