Assembly - Blumfeldt Felsquell Bedienungsanleitung

EN
16

ASSEMBLY

1 Take out all parts of the packaging. Please keep in mind that some
water may splash over the rim of a bowl, do not set up the cascade
fountain on a surface which may be damaged by water.
2 Open the door behind the fountain.
3
Connect the hose from the top of the water feature to the connector
on the top of the pump and place the pump on the floor of the water
chamber.
4
Connect the pump cable to the socket of the control housing on the
rear side of the solar panel.
5 Connect the LED light cable to the socket of the control housing;
6
Fill the water feature with water ensuring the pump is fully
submerged.
7 Close the door behind the fountain. Make sure direct sunlight shines
on the solar module.
8
Connect the ground stake to the solar panel and place the solar panel
in an area of direct sunlight.
9
The solar cascade fountain is now ready for use.