Inhaltsverzeichnis
Werbung
English
SAFETY AND OPERATING INSTRUCTIONS
HIGH PRESSURE CLEANER
For your own safety and for the safety of others, please
read these instructions carefully before using this
appliance.
WARNING! Always read the instruction for
electrical products carefully before use. It will
help you understand your product more eas-
ily and avoid unnecessary risks. Keep this instruc-
tion manual in a safe place for future use.
CONTENTS:
1. Machine data
2. Safety instructions
3. Assembly
4. Use
5. Service & maintenance
1. MACHINE DATA
INTRODUCTION
The high pressure cleaner is quick and efÞ cient for
cleaning vehicles, machines, boats, buildings, etc.,
by the removal of stubborn dirt using clean water and
chemical detergents.
When using chemical detergents, only use biodegrada-
ble types. Only clean vehicle engines in areas in which
suitable oil traps are installed.
TECHNICAL SPECIFICATIONS
Voltage
Input power
Working pressure
Max. pressure water supply
Max. water temperature
Working ß ow rate
Hose length
Weight
2. SAFETY INSTRUCTIONS
EXPLANATION OF SYMBOLS
In this manual and/or on the machine the following
symbols are used:
In accordance with essential applicable safe-
ty standards of European directives
Risk of damaging material and/or physical
injuries
SAFETY INSTRUCTIONS
When using electric machines always observe the safety
regulations applicable in your country to reduce the risk
of Þ re, electric shock and personal injury. Read the fol-
lowing safety instructions and also the enclosed safety
instructions.
Keep these instructions in a safe place!
ELECTRICAL SAFETY
Always check if your mains voltage corresponds
with the value on the type plate.
When replacing old cables or plugs: throw away old
cables or plugs immediately as soon as new ones
have replaced these. It is dangerous to put the plug
of a loose cable into the socket outlet.
When using extension cables:
Only use an approved extension cable that is suitable
for the machine's power. The cores must have a
diameter of at least 1.5 mm
is on a reel, unroll the cable in its entirety.
All electrical connections e.g. extension cable, must
be of an approved waterproof type for outdoor use
and marked accordingly. Extension cables must be
threecore, one of which is EARTH.
SWITCH OFF THE MACHINE IMMEDIATELY
IN CASE OF
AC 230 V
1. Malfunction in the mains plug, power cable or
damaging of cable.
1800W
2. Broken switch.
90 bar
3. Smoke or stench of scorched insulation.
135 bar
SPECIFIC SAFETY RULES
50º C
The USE and MAINTENANCE manual constitutes an
essential part of the cleaner equipment and should be
6.0 L/min
kept in a safe place for future reference. If you sell the
cleaner, the manual should be handed on to the new
3 m
owner.
7.5 kg
Before starting the cleaner, make sure that it is re-
ceiving water correctly. Operating the cleaner with-
out water could damage the seals.
Do not disconnect the plug by pulling on the electri-
cal cable.
If you are too far from the object you wish to clean,
do not move the cleaner nearer by pulling on the
high pressure hose; use the handle provided.
In versions not equipped with TSS device, do not
operate the cleaner for more than 1-2 minutes with
the gun closed as this could damage the seals.
Protect the cleaner from freezing during the winter.
Do not obstruct the ventilation grilles during opera-
tion.
The cross-section of any extension cables used
Remove plug from the mains immediately if
cable is damaged or cut
Read instruction manual
Denotes risk of electric shock
2
. When the extension cable
GB
9
Werbung
Inhaltsverzeichnis
