S-idee G171 Benutzerhandbuch Seite 17

3、CHARGE AND INSTALL A RECHARGEABLE BATTERY PACK
(1). First connect the plug of the rechargeable lithium battery
pack with the charger port (as shown in Fig. 4) (the
charger indicator light turns green); then plug the charger
into the power socket, (as shown in Fig. 5). At this time,
the charger indicator light is red), indicating that charging
is in progress: when the charger indicator light turns green
again, the charging time takes about two hours), the
charging is finished.
(Fig. 5)
(3). If (Fig. 7), connect the right socket of the battery
pack to the port of the battery compartment on the
remote control car, and then insert the rechargeable
battery pack into the battery compartment.
4. CHARGER / BATTERY PACK / CIRCUIT BOARD NOTES AND INSTRUCTIONS
(1). In order to prevent over-voltage charging of the iron-lithium battery pack,
the battery may be overheated or damaged orexploded; the charger adopts
a voltage-limiting protection device, to avoid the above situation. In order
to better protect the battery performance, it is recommended not to make
the battery pack continue charging for over 24 hours, to ensure safety
(2). This battery uses a low voltage, over-discharge protection device. When
the battery is over-discharged, re-charging can be activated to ensure the
durability or damage of the battery. In order to better protect the battery
performance, it is recommended nonuse the racer, please turn the racer power
switch to the "0FF" position, and remove the battery.
(3). This circuit board adopts the overheat protection function; when the circuit board
overheat protection function is activated, the racer (forward/reverse) function
will stop for about 3-6 seconds, and then resume the function.
(Fig. 4)
3.7V
3.7V
(Fig. 7)
(2). Remove the clamping-lock on the
battery cover of the racer base, and
open the battery cover. (Fig. 6)
(4). Cover the battery cover, and fasten
the clamping-lock on the battery
cover at the racer base (Fig. 8)
- 2 -
(Fig. 6)
(Fig. 8)
3.7V
3.7V