Multitone EkoSecure Hub Kurzanleitung

EkoSecure Hub / EkoTek Hub / EkoCare Hub
Quick Guide
Display
Emergency button
Back button
Scroll button
Select / Enter button
Timing sync with Timing Master
Radio beacon transmission
Configuration installed
PoE or 12 V power (Battery power when unlit)
Cover release clips
Product No.: EKSHUB-0A / EKTHUB /
EKCHUB Document No.: 9262-0209 issue 1
CONNECTIONS
POWERING THE DEVICE
To power the device:
a) Insert the 4 NiMH AA rechargeable batteries supplied
b) Connect the OUT port of the PoE injector to the LAN 1 PoE port
of the Hub using the supplied Cat5e patch cable
c) Plug the PoE injector into a mains power outlet
d) illuminates to indicate that the batteries are being charged
i. Allow up to 5 minutes to charge new batteries from empty
once PoE or 12 V DC power has been connected
e) The device will turn on automatically once the batteries have
been sufficiently charged to cover mains power failure
© Multitone Electronics plc, Multitone House,
Shortwood Copse Lane, Basingstoke, Hampshire, RG23 7NL
CONTROLS
Emergency button
▪ Press to raise an emergency alarm
▪ Configurable to operate on a single or double press
▪ Can be disabled through the Configuration menu in the web
interface
Box Contents:
Back button ❮
▪ 1 x Hub device
Press to return to the previous screen or undo a selection
▪
▪ 1 x Power-over-
Press and hold to deactivate an alert
▪
Ethernet (PoE)
Injector
Scroll button
▪ 4 x Batteries
Scroll through menu options
▪
▪ 1 x Cat5e patch
Select / Enter button
cable
Confirm the selected menu option
▪
▪ Power adaptors
Hold for 1 second to return to the default display screen
▪
▪ Cable ties
▪ Screws and wall
RAISING & CLEARING ALARMS
plugs
▪ 1 x Quick Guide
Once installed and configured, press
When an alert is raised, a text message containing the originating
device ID and alarm type is sent to a configured group of pagers.
To deactivate an alert, press and hold the
When an alert is deactivated, a text message is sent with the
originating device ID stating that the alarm has been deactivated.
RECEIVING MESSAGES
When a message is received:
▪ The device issues a signal tone
▪ The display backlight illuminates, if off
▪ The message is shown on the display
If multiple messages have been received, use the
select a specific message.
Once a message is selected, use the
responses (Accept, Reject, and Delete).
Scroll between response options using the
Select a response using the
Accepting an alarm informs the sender that help is on its way.
For further information on the use of this device, please see the
dedicated Operator Guide, part number 9262-0210.
www.multitone.com
❯
to raise an alert.
❮ button.
and ❯ buttons to
button to view the available
button.
❯ button.
COMPLIANCE
This product complies with the requirements of the following EU
Directives:
Radio Equipment Directive, 2014/53/EU
RoHS Directive, 2011/65/EU
This product complies with the requirements of the following UK
Statutory Instruments:
Radio Equipment Regulations 2017 (S.I. 2017/1206)
Electrical Equipment (Safety) Regulations 2016
(S.I. 2016/1101)
Environment Protection Regulations
(S.I. 2012/3032)
Restriction of Hazardous Substances
This equipment is manufactured to meet the RoHS Directive
2011/65/EU & UK S.I. 2012/3032 restricted substance thresholds
and does not make use of any exemptions.
A complete copy of the Declaration of Conformity and further detailed
technical information for this product may be obtained from
supportdesk@multitone.com or your Multitone representative.
Products covered by this Declaration:
Type of equipment: Lone Worker security system, radio control HUB
Model: EKSHUB-0A / EKTHUB / EKCHUB
Brand Names: Multitone EkoSecure / EkoTek / EkoCare
Signed:
Principal Approvals Engineer
WEEE Directive 2012/19/EU & UK S.I. 2013/1113
Product Disposal
At the end of its serviceable life, this product should
not be treated as household or general waste. It
should be handed over to the applicable collection
point for the recycling of electrical and electronic
equipment, or returned to Multitone or their agent, for
disposal.
B. R. Merchant,
Multitone Electronics plc
Basingstoke RG23 7NL
Dated: 03.02.2022