En - Preparing The Cabinet Niche - Miele EBA 2748 Bedienungsanleitung

en - Preparing the cabinet niche

The EBA 2748 is designed for installing
the M 2241 SC microwave oven into a
28 1/2" (724 mm) wide and
18 1/8" (460 mm) or 18 1/2" (470 mm)
high niche.
For the installation you need the
spacers "R" and "L 19 mm" supplied
with the microwave oven M 2241 SC as
well as the hooks and screws.
In order for the microwave oven to be
held securely by the hooks, the cabinet
niche has to be reduced in size from a
width of 28 1/2" (724 mm) to a width of
22 1/16" (560 mm).
For this purpose, additional wooden
strips  must be inserted into the
cabinet niche.
The wooden strips  must be at least
5/8" (16 mm) thick and must be at least
as long as the spacers.
The wooden strips  must be inserted
in such a way so that a centrally
positioned cabinet niche with a width of
22 1/16" (560 mm) is created.
12
J
: 3 1/8" (80 mm)
: 5 1/8" (130 mm)
: 13" (330 mm)
: 14 15/16" (380 mm)
: 3/8" (10 mm)
Discuss your requirements with your
architect, kitchen designer, and
installer.
During the planning phase, it is
essential to read the chapter
"Installation" in the Operating and
Installation Instructions of the
M 2241 SC microwave oven. There
you will also find the specifications
for the placement of the electrical
connection described in detail.
Further installation drawings are
available on the Miele homepage.
 Ask your kitchen builder or carpenter
to adapt the cabinet niche so that the
spacers can be installed as required.