easyteck M200 Bedienungsanleitung Seite 65

function, you need to use a network barring code, which can be obtained from the network
operator. If the code is wrong, an error message will be prompted on the screen. After se-
lecting a call barring option, continue to select Activate or Deactivate. The mobile phone will
prompt you to input the call barring code and then contact the network. A moment later, the
network will make a response and send the operation results to the mobile phone.
Auto redial: Set it to On or Off to enable or disable auto redial. If you set Auto redial to On,
the mobile phone will automatically redial the number a moment later if the called party does
not reply. The number of auto redial times can be set to a maximum of 10. In the auto redial
period, you cannot dial other numbers. To end the auto redial process, press the End key.
Note: This function requires support from the network operator to which the SIM card is
registered.
Call time reminder: To set single or circle tone in a call to make you know the time.
Connections
Contact the network operator to obtain the following network services:
Network selection: Set Network selection mode to Automatic or Manual. Automatic is recom-
mended. When Network selection mode is set to Automatic, the mobile phone will prefer the
network where the SIM card is registered. When Network selection mode is set to Manual,
25