BOMANN WKS 6043 CB Bedienungsanleitung, Garantie Seite 30

• Only use the appliance in a dry, indoor area. It is intended for do-
mestic use and similar areas of use such as e. g.:
- in staff kitchen areas in shops, offices and other working envi-
ronments;
- by clients in hotels, motels and other residential type environ-
ments.
It is not intended for use in farm houses or in bed and breakfast
type environments.
• The following symbols are on the product:
CAUTION:
Do not immerse the appliance into water for cleaning. Please
follow the instructions as stipulated in the chapter "Cleaning".
Notes for Use
Connected Wattage
The total power consumption of this appliance can be up
to 2200 W. With this connected load a separate supply line
protected by a 16 A household circuit breaker is recom-
mended.
CAUTION: Overload!
• If you use extension leads, these should have a cable
cross-section of at least 1.5 mm².
• Do not use any multiple sockets, as this appliance is
too powerful.
Mains Lead
Completely unwind the length of mains lead that you require
from the bottom section of the base. Please ensure that the
mains lead does not become tangled up.
Electrical Connection
1. Check whether the electrical voltage that you intend to
use is the same as that of the appliance. Details are to
be found on the label on the base.
2. Only connect the appliance to a properly installed safety
socket.
Switching On / Off
• Switching on (switch position: I):
Press the toggle switch downwards. The indicator light in
the switch lights up.
30
WKS6043CB_IM
• Switching off (switch position: O):
Press the toggle switch upwards. The indicator light in
the switch goes off.
Preparation
Before using for the first time, boil fresh water at least three
times in the appliance. Use only water without any additives
or ingredients.
Use
NOTE:
Always use fresh water.
1. Place the appliance on a flat surface.
2. Press the button in the handle to open the kettle.
3. Then fill in the water (max. 1.7 Litre). You can read the
filling level on the water level indicator of the kettle.
4. Close the lid.
5. Place the kettle flush on the base.
6. Switch on the appliance. The control lamp in the switch
will light up.
Pausing / Terminating Operation
There are two options to interrupt the boiling process or to
terminate it:
1. The appliance will shut off automatically after the boiling
process. The indicator lamp will go out.
2. Set the switch to the O position to pause or terminate
the boiling process.
10.07.20