TMC Next Wave Tank 85 Installations Seite 11

PARTS REQUIRED FOR INSTALLATION (NOT SUPPLIED)
• Heater
• Air Pump and flexible air tubing
• Non return valve.
• Residual Current Device (RCD) with a rated residual operating current not exceeding 30mA
• Additional connection fittings (depending on individual installation requirements).
• Bucket or similar container for preparing your saltwater.
• 60/85 litres of saltwater correctly prepared according to the instructions supplied with your chosen
synthetic salt, and at the correct temperature.
USEFUL TIP: We thoroughly recommend saltwater prepared with Tropic Marin synthetic sea salt (see
your local stockist for details and preparation advice).
• Measuring jug or similar vessel (for filling the Next Wave tank with water).
• A small cup, flat plate or something similar (to be used when filling the Next Wave tank with water to
prevent any substrate from being displaced).
AQUARIUM
SUBSTRATE
PREPARE
SALTWATER
USE A PLATE OR SMALL
CUP WHEN POURING
THE SALTWATER ONTO
THE SUBSTRATE
1. If you are planning to add aquarium decor e.g. live rock or replica live rock,
position these as required.
Please Note: Ensure all aquarium decor is correctly prepared before
introducing to the Next Wave tank .
2. Carefully pour your selected aquarium substrate into the Next Wave tank .
TMC EcoSand is recommended (see your local TMC stockist for details).
3. Place a small cup, flat plate or something similar on top of the substrate
(to prevent any substrate from being displaced) and carefully pour the
prepared saltwater.
Please Note: The prepared salt water must be at the correct temperature
for the Next Wave tank before adding to the tank.
Please Note: Due to various factors such as evaporation, the water level
in the Next Wave tank will change. Ensure that the water level in the tank,
the protein skimmer chamber and filtration chamber is always closely
monitored. As water evaporates, the salinity level in the tank will also
change so ensure that the specific gravity (SG) of the tank is measured
using a hydrometer, and the tank is regularly topped up with freshwater
or saltwater as necessary to reach the correct specific gravity (SG) and the
required water level.
Please Note: When topping up the tank with new saltwater, the saltwa-
ter must always be prepared correctly and according to the instructions
supplied with your chosen synthetic salt and any water added to the Next
Wave tank must be at the correct temperature.
CAUTION: Livestock should NOT be introduced to the Next Wave tank
until water parameters have been tested and it is safe to do so. Regularly
test the water parameters with reliable test kits and consult your local
retailer for further advice if necessary.
11