Black & Decker KG1200K Bedienungsanleitung Seite 5

disconnect from the socket. Keep the cord away
from heat, oil and sharp edges.
Store idle tools
When not in use, tools should be stored in a dry,
locked up or high place, out of reach of children.
Maintain tools with care
Keep cutting tools sharp and clean for better and
safer performance. Follow the instructions for
maintenance and changing accessories. Keep
handles and switches dry, clean and free from oil
and grease.
Repairs
This tool complies with relevant safety
requirements. Repairs should only be carried out
by qualifi ed persons using original spare parts;
otherwise this may result in considerable danger to
the user.
Electrical safety
This tool is double insulated; therefore
no earth wire is required. Always check
that the power supply corresponds to the
voltage on the rating plate.
Additional safety instructions for angle
grinders
Read the instruction manual before use.
Wear safety glasses or goggles when
operating this tool.
Wear ear protection when operating this
tool.
• Always use eye and ear protection when
operating this tool.
• Personal protective equipment such as dust
mask, gloves, helmet and apron should be
worn.
• Do not cut or grind light metal with
a magnesium content exceeding 80%, since
this type of metal is fl ammable.
• Only use grinding and cutting discs and other
accessories recommended in this manual.
• Make sure that the maximum speed of the
grinding or cutting disc exceeds the no-load
speed of the tool.
• Do not use grinding and cutting discs that do
not conform to the dimensions stated in the
technical data. Do not use separate reducing
bushings or adapters or make unauthorised
modifi cations to adapt large hole abrasive
wheels.
All manuals and user guides at all-guides.com
• Do not cut workpieces requiring a maximum
• Do not use cutting discs for side grinding.
• Inspect grinding and cutting discs before each
• Ensure that the abrasive product is correctly
• Ensure that blotters are used when they are
• When applying a threaded hole disc, ensure
• Never use the tool without the guard.
• Check that the workpiece is properly supported.
• Do not exert side pressure on the grinding or
• Ensure that sparks resulting from use do not
• Beware that after switching off the tool the
• Ensure that ventilation slots are kept clear
• Abrasive wheels shall be stored and handled
Features
This tool includes some or all of the following
features.
1. On/off switch
2. Lock-off button
3. Lock-on button
4. Side handle
5. Spindle lock
6. Guard
Assembly
Warning! Before assembly, make sure that the tool
is switched off and unplugged.
depth of cut exceeding that of the cutting disc.
use. Do not use chipped, cracked or otherwise
defective discs.
mounted and tightened before use and run the
tool at no-load for 30 s in a safe position, stop
immediately if there is considerable vibration or
if other defects are detected. If this condition
occurs, check the machine to determine the
cause.
provided with the bonded abrasive product and
when they are required.
that the thread is long enough to accept the
spindle length.
cutting disc.
create a hazard e.g. do not hit persons, or ignite
fl ammable substances.
wheel continues to rotate for a short period.
when working in dusty conditions. If it
should become necessary to clear dust, fi rst
disconnect the tool from the mains supply.
Avoid damaging internal parts, use a soft brush
or dry cloth, do not use metallic objects.
with care in accordance with manufacturer's
instructions and always store grinding and
cutting discs in a dry place.
ENGLISH
5