Setting The Alarm; Setting The Volume Of The Ringtone; Setting The Regional Prefix - Renkforce DF-DP-400 Bedienungsanleitung

10.2 Setting the alarm

1. When the receiver (1) is in place, press the "SET / STORE" button.
The settings menu will be displayed.
Æ
2. Use the arrow buttons to navigate through the submenu until the display shows "SET 5 ALERT".
3. Press the "SET / STORE" button.
The alarm time will be shown on the display in the format "HH-MM" followed by the parameter "ON" (when the
Æ
alarm is enabled) or "OFF" (when the alarm is disabled).
4. Press the "SET / STORE" button again.
The set hour will flash on the display.
Æ
5. Configure the desired hour setting using the arrow buttons, and then confirm your entry by pressing the "SET /
STORE" button again.
The set minute will flash on the display.
Æ
6. Configure the desired minute setting using the arrow buttons, and then confirm your entry by pressing the "SET
/ STORE" button again.
The alarm status will flash on the display.
Æ
7. Set the desired alarm status using the arrow buttons, and then confirm your entry by pressing the "SET / STORE"
button again.
8. Press the "DEL/R" button to exit the settings menu.
Note:
– The alarm will sound at the set time for a duration of 1 minute.
– To switch the alarm off, press any button or briefly remove the receiver and hang it up again.
– The alarm will switch off automatically:
– If the receiver is off the hook.
– If the phone is ringing.
– Within 6 seconds of a missed call.

10.3 Setting the volume of the ringtone

Use the sliding switch on the back of the base station (6) to set the ringtone volume. You can choose from the following
settings:
HI: Loud
LO: Quiet
OFF: Ringtone off

10.4 Setting the regional prefix

1. When the receiver (1) is in place, press the "SET / STORE" button.
The settings menu will be displayed.
Æ
2. Use the arrow buttons to navigate through the submenu until the display shows "SET 2 CODE".
3. Press the "SET / STORE" button.
"CODE" will appear on the display, followed by the current prefix.
Æ
If no prefix has been set, "CODE---" will be displayed.
Æ
4. Press the "SET / STORE" button again.
The first number of the prefix will flash.
Æ
19