After Use; Battery Replacement - Eks 0620 Bedienungsanleitung

Taking the temperature in SCAN mode:
• When you press the "SCAN" button, you will get the actual temperature immediately.
• If you press and hold the "SCAN" button, the measurement will be updated continuously.
• Applications include temperature measurements for water, milk, cloth, skin or other
objects.
Note:
This mode gives the surface temperature which is different from the body temperature.
To get the room temperature:
• For room temperature, the thermometer should be placed on a table
away from direct sunlight or air conditioner draughts.
• When turned off the room temperature will always be shown on the
screen with icon.
• The room temperature can be reference after 5min later.

After use

• Power off: To extend battery life the device will automatically shut off if left idle for more
than  minute. The LCD will only show the room temperature.
• Clean the probe after each use to ensure an accurate reading and avoid
cross contamination. (See the section of Care and Cleaning for details.)
• After measurement, please push back the raised brim on the sliding panel above of LCD
screen to protect the probe.
IMPORTANT: Care & cleaning
The probe is the most delicate part of the thermometer. Handle with care when
cleaning the lens to avoid damage.
a. After measurement, use a cotton swab with alcohol (70% concentration) to clean the lens.
b. Allow the probe to dry completely for at least  minute.
c. Storage temperature range: -0~50°C (-4~°F), RH≤85%
d. Keep the unit dry and away from any liquids and direct sunlight.
e. The probe should not be submerged in liquids.
Note:
• If the device is dropped, please check that it is not damaged. If you are not sure if it is
damaged, please send the complete devise to the nearest retailer for recalibration.

Battery replacement

When the battery icon in the display flashes, the battery should be
replaced.
• First make sure the thermometer is in "forehead mode".
• Open the battery cover by inserting a coin to twist it clockwise. The
battery is located under the round cover at the rear of the device.
• Flip the battery out with a small screwdriver.
• Insert the new battery under the metal hook on the left side and press
the right side of the battery down until you hear a click.
• Replace the battery cover
• This device is supplied with one lithium cell battery (CR03x).
The positive (+) side up and the negative (-) side pointed down.
• Keep the battery away from children.
• Disposal of the used batteries: please comply with the local regulation.
6