NateoSante EOLIS Air Manager 600 Betriebs-Anleitung Seite 17

EOLIS Air Manager exploded view
1200 / 1200S MODEL
Front cover
Installing the EOLIS Air Manager
• Take the unit out of its packaging. Keep the origi-
nal box throughout the unit's lifespan.
• Install the floor support (for models 1200 and
1200S) by screwing the 4 floor support screws
into the EOLIS Air Manager base (the narrowest
side of the support is the back side of the unit):
back
front
• Open the cover to access the filter compartment.
To open the cover, hold it at the top and the bottom,
pull on the top, and then gently at the bottom.
• Remove the filter block from its protective
packaging, and put it back in place, with the tabs
facing outwards.
• Plug the unit into an electrical outlet.
EOLIS Air Manager operation
You have finished installing the unit, and now it is
ready for operation.
Before pressing the switch on the back of the unit,
read the following instructions and recommenda-
tions carefully to get the most out of your EOLIS
Air Manager.
How does EOLIS Air Manager work?
Once the unit is turned on, polluted air is drawn
into the front of the unit, and then moves through
the entire filtration system. The polluted air is then
filtered and propelled out on the top of the unit
(behind the screen).
You can use the control panel or smartphone app
to choose the operation mode, fan speed and
optional features.
17 - EOLIS Air Manager 600 600S 1200 1200S 17 - EOLIS Air Manager 600 600S 1200 1200S
Pollution sensors
(particles, VOCs)
Filter block
+
Motor
turbine
UV-C Lower arch
lamps
The filter block: nominal operation
Your filter block is composed of: an anti-bacterial
pre-filter, a very high density (VHD) activated
carbon filter, a medical-grade HEPA H13 filter (or
ULPA U15) and a photocatalytic filter.
The specific functions of these filters:
Bactericidal virucidal acaricidal pre-filter
(EN 1276, EN 14675 certified)
• Conserves the HEPA filter's lifespan by capturing
macro-particles.
• The pre-filter has a bactericidal, virucidal and
acaricidal treatment which allows it to fight
bacteria, viruses and dust mites.
Very high density (VHD) activated carbon
filter
• Traps toxic gases, pesticides, kitchen and
tobacco smoke.
• Neutralises bad odours.
• Adsorbs VOCs (Volatile Organic Compounds),
formaldehyde,
sulphide, ammonia vapours, bleach vapours, etc.
• Accelerates the breakdown of active oxygen
present in the atmosphere.
Medical-quality HEPA H13 filter
(EN 1822 certified)
• Eliminates micro-particles with a dimension
greater than 0,0001 mm (0,1µm) for the HEPA
H13 filter.
• Traps fine dust, dust mites, pollens, animal hair,
diesel particulates, pesticides, micro-organisms
(bacteria, viruses, fungus, spores, mould...)
Photocatalytic filter
• Working together with the Ultra Violet lamps,
this filter removes VOCs.
For optimal filtration and correct use, you must
replace the filter block regularly (see p. 21 to 22).
Upper arch
Touch screen
+ microcontroller
Back cover
Power supply
card
benzene, toluene, hydrogen
EN EN