Led Light - Skoda 000 051 763R Benutzerhandbuch

› When CLAMPS REVERSED appears on the LCD, an alarm sounds to
EN
indicate incorrect connection. Connect the clamps correctly. The LCD
shows JUMP START READY, then start the engine.
+
CLAMPS REVERSED
88.8 88.8
v
PRODUCT v
BATTERY
888
A
888
%
JUMP START READY
› When PRESS BOOST BUTTON appears on the LCD, an alarm
sounds, which means that the vehicle battery voltage is too low.
Press the "BOOST" button until JUMP START READY appears on the
LCD, then start the engine within 30 seconds.
› If no vehicle battery data is displayed on the LCD, the alarm does
not sound, which means that the vehicle battery is discharged or
removed; check that the terminals are connected correctly, press
the "BOOST" button until "JUMP START READY" lights up and then
start the engine within 30 seconds.
After starting the vehicle, disconnect both clamps and let the
engine run.
Charging mobile phones or tablets
› Connect the USB cable (C) to the USB 5V/2A or USB 5V/1A output
port.
› Connect the other end of the USB cable to the mobile phone (Fig. 1)
or to the tablet (Fig. 2).
› Push the switch to start charging.
4
(Fig. 1)
Charging 19V electronic equipment, e.g. laptops
› Connect the connecting cable (B) to the USB 19V / 3.5A output port.
› Select the appropriate adapter for the notebook and connect it to
the cable (B) and the notebook.
› Push the switch to start charging.
Charging 12V electronic equipment
› Connect the 12V vehicle accessory cable to the 12V/10A output
port.
› Push the switch to start charging.

LED light

› Press the switch for 3 seconds to turn on the LED light.
› When pressing the switch slightly, you can toggle between 4 modes
of the LED light in the following order: normal, strobe, emergency, off.
(Fig. 2)