Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
This product allows you to choose the operating mode (extraction or filtering) according
to installation.
This model should only be set in the filtering version.
On first start-up for a few seconds the display shows which mode is active.
Filtering: the display indicates: FC1
Extraction: the display indicates: FC0
During this phase, you can change the mode by pressing key: 5
To confirm the selection, press the key: 6
To reference the operating mode selection, disable and re-enable voltage to the appliance.
Key:6 on/off motor: pressing the key starts both the motors at first speed or if already on it causes
switch off.
This device is equipped with a dual motor, on the right and left, with independent and/or
synchronised operation.
To select each motor, use key 3 (for the left motor), use the key: 8 (for the right motor).
To increase and reduce the speed of the motor, use the key: 4 (to decrease), use the key: 7 (to
increase)
Key: 1 synchronises the two motors aligning the speed between the two motors at the highest
speed
use the key: 4 (to decrease), use the key: 7 (to increase).
To switch off a single motor use the key: 3 (left motor) use the key: 8 (right motor).
Clock adjustment: to adjust the time, simultaneously press the key: 4 and the key: 7 with the
motors off and lights off, using keys 4 and 7 set the correct time, to confirm simultaneously press
the key: 4 and the key: 7.
Timer: to enable this function with the motor on, simultaneously press the keys 5 and 7, the timer
indicates 10 minutes to increase or decrease the time using the keys 7 and 4 .
Filter management: on pressing the key: 5 on the display the wear status is displayed of the filters
expressed as a percentage: FC (carbon filters),on subsequent pressing the key: 5 the display shows
the wear status of the grease filters FG (grease filters).
Saturated filters: if the key: 5 flashes with the hood on, or remains fixed in standby, the display
on switching on the motor will display the status of the filters: you must wash the grease filters or
replace the carbon filters.
Reset filters: following maintenance or replacement of the various filters to reset the alarm press
the key: 5, press the key for a long time: 5 the timer will reset and a beep confirms the operation
carried out.
2
1
3
4
OPERATION
Display
20
6
5
7
8
Werbung
