Inhaltsverzeichnis
Werbung
Scanning Channels
To Start Scanning:
1. Briefly press the
stop scrolling and receiving when matched channel and sub codes detected.
2. After the end of transmission, press the PTT button within 5 seconds to respond. The device will
resume scanning after end of any received activity.
3. If you press PTT button when the device is scrolling, the transmission will be on the 'home channel'.
4. Press
button to exit scanning feature.
Notes:
If the device stops on an unintended/undesired transmission, press
scan OR temporarily remove that channel from the scan list by pressing and holding
seconds. Press
to exit and re-enter scan mode to restore removed channels to the scan list.
LED Lamp
Press the
button to turn ON/OFF the lamp.
Automatic Power Saving
This feature is enabled by default to enhance battery life.
Emergency SOS Mode
User can use this feature to emit SOS signal. To enter emergency SOS mode:
1. Press and hold the SOS button for 3 seconds. The RED LED light will be activated.
2. Press the button again to deactivate.
Water Activated LED
Once the devices are dropped into water, white LED will be activated automatically to ease user to
locate the devices in dark environment. After retrieve the devices, press any button to deactivate
except
button.
Note: Radio floats with designated 1200mAh NiMH batteries. It may not float with other batteries.
14
button to start scanning. SCAN icon will appear in the display. The device will
button will overwrite and activate LAMP feature.
or
button to resume
or
for 3
Werbung
Inhaltsverzeichnis
