Receiving And Transmitting; Monitor Button; Setting The Channel - Decross DC93 Bedienungsanleitung

RECEIVING AND TRANSMITTING

To communicate, all radios in your group must be set to the same channel and sub code.
1. To talk, press and hold the PTT button. When transmitting, the
button when you are finished talking. Do not use the radios closer than five feet apart.
2. When receiving, the

Monitor Button

1. Press and hold
current channel.
2. You can also press
3. Release the button to exit monitor mode.
PTT Time out Timer
When you press PTT buttons for more than 60 seconds, radio will stop transmitting. This is to prevent
accidental transmission.
FEATURES

Setting the Channel

1. Press the button until the channel number starts to flash.
2. Press or
Channels and Frequencies
Max
Frequency
CH Power
(MHz)
Output
1 446.00625 0.5W
2 0.5W
446.01875
3 446.03125 0.5W
4 446.04375 0.5W
Channels: 16 PMR (Note:only Channels 1 to 8 are available by default. Channels 9 to 16 need to be
activated by user before they can be selected. Channels 9 to 16 should only be used in countries where
these frequencies are allowed by government authorities. Channels 9 to 16 are not allowed in Russia)
12
icon is shown.
button for 3 seconds to enter monitor mode and listen for weak signals on the
button to check for activity on the current channel before you talk.
button to change the channel number. Press the PTT button to exit menu.
Frequency
CH
(MHz)
5 446.05625
6 446.06875
7 446.08125
8 446.09375
Max
Frequency
Power
CH
(MHz)
Output
0.5W 9 446.10625
0.5W
10 446.11875
0.5W 11 446.13125
0.5W 12 446.14375
icon is shown. Release the PTT
Max
Frequency
Power CH
(MHz)
Output
0.5W 13 446.15625
0.5W 14 446.16875
0.5W 15 446.18125
0.5W 16 446.19375
Max
Power
Output
0.5W
0.5W
0.5W
0.5W