Jula 417-013 Bedienungsanleitung Seite 11

The figures in the text refer to the illustrations. Keep to the specified minimum distances. Fix the mounting
bracket to the wall (see figure). Two mounting screws and plugs are included for installation. Drill holes
into the wall. Push the plugs in and screw the bracket in place. Make sure the bracket is vertical. Remove
the safety screw and take out the mounting lever. Re-fit the safety screw and hook the mounting lever
onto the bracket to hang up the heater. Plug in the power cord. The heater is ready for use. The heater
must not be connected permanently to the mains power supply.
NOTE!
When the heater is turned on for the first time, or after a long period of storage, it is normal for it to
produce odour and fumes. These disappear after a few moments of operation.
Description
This unit is an electrical convector heater. It is fitted with a thermostat to ensure correct temperatures and
to protect against overheating. A control lamp comes on when the heater starts to heat up. The
thermostat switches the heater on and off to maintain the room at the set temperature. The built-in
overheat protection switches the heater off if it gets too hot and automatically switches it on again when it
has cooled down. The heater is always ready for use. Turn off the heater by unplugging the cord.
Use
The temperature knob and the marking on the
casing show the setting of the thermostat.
= Frost protection setting (approx. 5°C)
Setting the required room temperature
Turn the knob clockwise as far as possible. Wait until the required temperature has been reached. Slowly
turn the knob back until the control lamp goes out. The position of the knob now corresponds to the
temperature required.
• Unplug the power cord and allow the appliance to cool before cleaning.
• Clean the casing with a damp cloth and then wipe with a dry cloth.
Do not use any detergents or abrasives.
•
• Never allow water to enter the heater.
Storage
Store the heater in a dust-free, dry area if it is not going to be used for some time.
ENGLISH
INSTALLATION
OPERATION
MAINTENANCE
11