Mounting Your Induction Cooker - CombiSteel 7505 Serie Gebrauchsanweisung

To remove the control box assembly, turn the induction cooker on its side. Remove the two locking screws which
connect the control box to the cooker. Pull down & remove the control box from the induction housing. The
control box will be connected to the induction cooker by a cable. To remove the cable from the cooker, loosen
the two thumb-screws & pull out the connector. The control panel can now be connected to the side of the
double induction cooker. Remove the small metal housing from the side of the cooker. This housing can be placed
over the centre opening to prevent dust & grease from corroding the connector. Screw the cable connector to
the side connection. Tighten the screws, insert locking teeth into the mounting slots & mount two locking screws
into the bottom of the induction cooker h ousing.

7. Mounting your induction cooker

For a built-in applications, your counter or table thickness must not exceed 50mm. Your induction cooker must
have the proper ventilation in order to operate correctly. There must be at least 250mm of space available under
a mounted induction cooker. Cabinets housing the induction cooker should have both vents & circulation fans
installed. The inside temperature of the cabinet must not exceed 32°C. To mount your induction cooker, you must
first remove the control panel (refer to Countertop use for instruction). Place the template of the induction
cooker on the surface you are preparing for the install. Centre the template, allowing a minimum of 100mm of
countertop space on each side of the induction cooker. The template measures 670 mm long x 340 mm wide.
Once you insert the induction cooker into the cut out, the edge of the cooker will sit 12.75 mm above the surface
of the countertop. Apply a thin bead of 100% rubber silicone sealant around the surface perimeter of the
mounted induction cooker.
8
www.combisteel.com