Superior SP120 Anleitung Seite 9

- Fit the elbow Ø 40 mm [1], with the hose [4]
already connected, onto the primary air inlet.
Ensure that the hole at the top of the elbow is
aligned with the hole in the primary air inlet.
Secure the elbow using the screw M5 [8] provided
in the kit. (Fig. 2)
- Remove the knockout [D] from the appliance
side panel, taking care not to buckle or scratch
the panel. (Fig. 3)
- Refit the previously removed side panel.
- Align the slots in the connector [2] with the holes
to be found in the appliance side panel and fasten
the connector using the self-tapping screws [6]
provided in the kit. (Fig. 4)
- Using the hose, connect up the connector and the
elbow already fastened to the appliance, locking
them in place with the hose clip [5] provided in
the kit. (Fig. 5)
- Check that the hose does not come into contact
with parts of the appliance that move during
operation.
- Refit the previously removed cladding in the
reverse order to removal.
- Connect the appliance to any fresh air intake.
Fig. 2
Fig. 3
Fig. 4
2
Fig. 5
H07027540 / DT2000900-03
1 8
D
6
8 1
DT2033752-0
DT2033803-0
DT2033804-0
5
DT2033805-0
9