Electronic TCD-386WE Bedienungsanleitung Seite 16

Repeat play

You can listen the desired tracks or folder repeatedly by this function.
Intro play (by remote control)

You can listen the beginning (10 seconds) of each track in a cd by this function & saving your time to search
the desire song
Random play

You can listen all the tracks or folder in a random order by this function
CD disc programming (by remote control)
Up to 32 tracks can be programmed for CD or MP3 file and play in any order. Before use, be sure the system
is at stop mode before programming:-
1. Set in CD/USB mode & stop the CD playback.
2. Press the Program" button, " PROG " will appear on LCD display (2). Moreover, it will indicate program
no. and digits for track no. To be programmed.
3. Select a desired track by pressing skip
4. Press the " Program " button to store the trace into memory.
5. Repeat steps 3 and 4 to enter additional tracks into the memory if necessary.
6. When all the desired tracks have been programmed, press CD " Play/pause/stop "
play the disc in assigned order.
7. To cancel the programmed file, press "stop" button on remote handset until " PROG " is disappear on
LCD display (2)
Playback of MP3 song via USB storage media or memory card
Connecting
The system is able to decode and playback all MP3 file which stored in
the memory media with USB connecting port or SD/MMC memory card.
1. Set Function selector (6) at USB/SD position and then press source
button (4) to select " USB or card" mode.
2. Plug-in the USB plug with the face up & make sure it going into
completely or insert the memory card in the direction of the arrow
as shown in the label on the underside of the memory card slot.
Insert straight without bending.
Connecting the USB upside down or backwards could

damage the audio system or the storage media (USB
thumb drive / SD/MMC card). Check to be sure the
direction is correct before connection.
3. The system will start reading the storage media automatically after
connecting, and LCD display (2) will show the total number of MP3
files and total number of folder being detected.
4. Repeat the same playback procedure as playing CD/MP3 disc as above
Remark
The system can detect and read the file under MP3 format only though the USB port.
-
If connect the system to MP3 player via the USB socket, due to variances in MP3 encoding
-
format, some MP3 player may not be able to play via the USB socket. This is not a
malfunction of the system.
USB port does not support connection with USB extension cable and is not designed for
-
communication with computer directly.
noted:
Remove the stylus protector.
-
Be sure that the tone arm is being detached from the tone arm rest before
-
operating and re-secured again afterwards.
1. Select to " Phono " function (6).
2. Set the speed selector to the proper position depending on the record to be played.
3. Place the record on the platter (use the spindle adaptor if required).
4. Lift the tone arm from the rest and slowly move it to the record side. The platter will start to rotate.
(24) or buttons (13).
Phono
button (16) to