Error Codes - ETNA VW149AZT Gebrauchsanleitung

ERRORS

Error codes

P1 P2
* *
*
*
*
* *
*
*
EN 22
P3 P4 P5
*
* *
* * *
* * *
* * *
* * *
* *
* *
Should the appliance become overfilled or exhibit excessive
leaking, shut off the inlet tap and alert the service department.
interference type solution
Insufficient water supply • Make sure that the water
• Check if the supply hose
• Restart the dishwasher
Flooding safety enabled • Close the water faucet
The dishwasher is not • Check if the drainage hose
pumping out
• Check the bottom sieve
• Restart the dishwasher
Heating error • Please contact the service
Flooding sound signal • Turn off the dishwasher
activated
Interference in the • Please contact the service
electronics
Temperature in the • Please contact the service
machine is too high
Interference of heating • Please contact the service
sensor
faucet is completely open
and that there is no crack
in the supply hose
is clogged
Please contact the service
department if the problem
persists
and contact the service
department
is connected
and filter group
and terminate the last
selected program
department
and close the water faucet
Please contact the service
department
department
department
department