Troubleshooting - Denqbar DQ-2800ER Originalbetriebsanleitung

12. Troubleshooting

1. Engine does not start
Enough gas?
YES
Ignition key in the ignotion lock on
position "ON and fuel tap open?
YES
Enough oil?
YES
For electrical start: battery
charged enough?
YES
Does the spark plug work?
YES
If the engine still does not start, please send the generator to one of our authorized dealers for repair.
Inspection:
1. Pull off plug connector from the spark plug, clean spark plug and plug connector.
2. Disassemble spark plug and insert into plug connector.
3. Connect spark plug to earth.
4. Pull the wire starter and see whether there is an ignition spark.
2. Connected consumers do not turn on
Is the operating display on?
Yes
Is there a short circuit in the
connected consumer?
NO
NO
NO
NO
NO
Replace spark plug
No
No
Yes
66
Fill in fuel
Put ignition key to position "ON" and
open the fuel tap
Fill in oil
Recharge or replace the battery
no spark
Have generator repaired by
authorized specialist
Please send generator to authorized
dealer for repair
Please send generator to authorized
dealer for repair
1. Exchange consumer
2. Have consumer repaired
© by DENQBAR GmbH
http://www.denqbar.com