Important Safeguards - Redmond RHB-2942-E Bedienungsanleitung

Carefully read all instructions before operating the appliance and save them for future
reference. By carefully following these instructions you can considerably prolong the
service life of your appliance.
The safety measures and instructions contained in this manual do not cover all possible
situations that may arise during the operation of the appliance. When operating the
device the user should be guided by common sense, be cautious and attentive.

IMPORTANT SAFEGUARDS

• The manufacturer is not responsible for any failures
arising from the use of this product in a manner
inconsistent with the technical or safety standards.
• This appliance is intended to be used for non­
industrial use in house hold and similar spheres
of application. Industrial application or any
other misuse will be regarded as violation of
proper service conditions. Should this happen,
manufacturer is not responsible for possible
consequences.
• Before installing the appliance, ensure that its volt­
age corresponds with the supply voltage in your
home (refer to specifications on the appliance rat­
ing plate or technical data).
8
All manuals and user guides at all-guides.com
• When using the extension cord, ensure that its volt­
age is the same as specified on the appliance. Using
different voltage may result in a fire or other acci­
dent, causing device damage or short circuit.
• Always unplug the unit after use, before cleaning,
or moving. Never handle plug with wet hands. Do
not pull the power cord to disconnect from the
out let; instead, grasp the plug and pull to discon­
nect.
• Keep the power cord away from hot surfaces or
sharp edges. Do not let the cord hang over the edge
of a table or a counter. Do not bend, twist, stretch,
or bind the power cord by force.
NOTE: damaged cord may cause a shock, fire,
or lead to a failure that will not be covered by
the warranty. If the cable is damaged or re-
quires replacing, contact an authorized service
center only to avoid all risks.
• Do not operate the unit on soft or unstable sur­
faces.