Ferroli Lira Installation, Betrieb Und Wartung Seite 39

Do the programming carefully, without overlapping the activation and/or deactivation times on the same
day in different programs.
Access the fourth sub-men WEEKEND PROGRAM to enable, disable and set the chrono functions for the weekend.
Follow the same procedures of the previous paragraph. Up to two operation phases delimited by the set times can
be set.
To avoid unwanted startup and shutdown operations, activate only one program at a time.
Access the fifth sub-menu to exit the chrono menu and access the main one.
4.6.4 Menu 04 – select language
With this selection it is possible to set the desired language from those available.
4.6.5 Menu 05 – standby mode
By selecting ON in STANDBY mode the corresponding symbol on the display lights up and the stove shuts down
automatically when the room temperature has reached the set value for a given time.
The next restart in automatic will be possible only when the room temperature falls below the set value by a few
degrees (default 2°C).
With the OFF selection, the modulation function is active but not the STANDBY mode. Therefore when the
temperature exceeds the set value the stove will operate at minimum power.
4.6.6 Menu 06 – buzzer
With this selection it is possible to activate or deactivate the stove alarm buzzer.
4.6.7 Menu 07 – initial loading
Allows the preloading of pellets for a given time. This function can only be activated when the stove is off and cold
and is used if the auger is empty due to no more pellets. It is started with button P1 and stops with button P4.
4.6.8 Menu 08 – stove status
This selection is reserved exclusively for the authorised COLA service centre technician.
4.6.9 Menu 09 – settings by technician
This selection is reserved exclusively for the authorised COLA service centre technician.
Modification of the technical parameters of menu 09 must be done by an authorised and competent
technician; any modifications made randomly can cause serious damage for which COLA declines any
liability.
4.6.10 Menu 10 – settings by technician
This selection is reserved exclusively for the authorised COLA service centre technician.
4.6.11 Menu 11 – ECO mode
The selection ON in the ECO mode limits the stove to operate in modulation, i.e. at minimum power and minimum
ventilation. The display shows NIGHT ECO and the corresponding symbol lights up.
4.7 Remote control
The remote control is a device that transmits through an infrared diode. Therefore it must be pointed towards the
receiver unit fitted in the control panel.
The remote control allows the following operations:
39 LIRA