Power Supply - Gastrodomus GA2100CTN Bedienungsanleitung

Notice:
The appliance is not to be used by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction.
· children being supervised not to play with the appliance.
· Do not store explosive substances such as aerosol cans with a flammable propellant in this
appliance.
Instruction for use
This appliance is only fit to store the food and drink for commercial use.
Installation
1. The appliance must be stored in dry and ventilated indoors. To keep the normal operation of
this appliance, keep this appliance away from direct solar radiation and heaters. Please note,
the most suitable working temperature is +16℃~+35℃.
2. Key Precautions
During installation, please keep this appliance in good ventilation. Make sure there are
enough space at the bottom, back and base of this appliance so as to keep the good
ventilation.
1. This appliance cooler must have a clearance of 5 inches/12,7 cm at top and 3.9 inch/10 cm at each side.
For the sake of safety, while disassembling the package, including the pallet at the bottom of the
appliance and the foam pad as well as the tape inside the cabinet as support, we advise that it
should be done by two more people.
After the disassembly of package, the appliance should stay in horizontal position. You can use
foot to adjust, if the appliance is unstable. If the appliance is equipped with wheel you should use
wood or other solid thing to block it. Lock the wheel in case that the appliance is moved by
outside force.
Before plugging in, read carefully through the labels and manual instruction to ensure that the
plug and power supply are in accordance with safety regulation.
Correct way to plug in and out the plug. While plugging in, make sure that the plug and socket
are completely fit with each other; While plugging out，make sure that the plug and socket are
completely disconnected. Don't directly drag the plug line.
If this appliance wouldn't be used for a long time, please disconnect the power supply. Please
completely clean the appliance to avoid the peculiar smell.
To secure your personal safety, this appliance must be ground connected. The appliance is
equipped with a ground plug with a ground wire. The plug must be plugged into the socket and
4
42
the socket must be correctly grounded. If you don't understand or suspect the grounding problem,
please confirm with the electrical personnel or the service center.
If the plug line is not long enough to connect the plug, please turn to a expert to change the
wiring circuit or relocate the socket.
If the power supply is disconnected, please restart the appliance after 5 mins to avoid the
damage of compressor.
Note: If the appliance don't stay in the right vertical position during the process of storage and
carrying. Please restart the appliance after 12 hours of vertical and still position.
Note:Please clean the shelves and the interior before the first use of this appliance.

Power supply

This appliance use alternating current. You can refer to the rating labels to know the voltage and
frequency. This appliance should use the independent three-pole socket. The socket should be
equipped with a good ground line, the ground line cannot be connected to water pipe, gas pipe,
lightning rod and other pipe and circuit. If any doubt happens, please contact the local dealer and
expert.
Warning:this appliance must be grounded.
This appliance is equipped with a 10A three pin plug and should use the corresponding 10A
three pin socket. The suitable fuse and other electric-controlled safety equipment should be
equipped.
Special Remark: The ground line at the end of socket should be in line with appliance standard.
Key point:
The colors of power line are in accordance with following code:
Yellow-green line：ground line
Blue line：zero line
Brown line：firing line
Please note the wire code represented by the color of power line, to identify the relevant
terminals: Here is the rule:
The yellow-green represents ground line, the terminal identity is "E"; the blue represents zero line,
the terminal identity is "N" or the color is marked black. Brown represents firing line, the terminal
identity is "L" or the color is marked red.
5
43