Werbung
Verfügbare Sprachen
Verfügbare Sprachen
When both cutting edges of the blade have become worn they must be replaced
as a pair. The blades can be re- sharpened, but this must be done by an
experienced person using an oil stone. We do not recommend this be done as the
weight of each blade is critical to maintain the balance of the cutting disc. Any
imbalance could cause damage to the machine and possible injury to the operator.
How do I maintain this product?
1. Warning: During maintenance and cleaning ensure the machine is
disconnected from the mains.
2. When the appliance is stop ped for servicing, inspection, or storage, or to
change an accessory, switch off and pull the plug from the mains supply
before making any inspections, adjustments, etc.
3. If an extension cord is used it shall not be of lighter grade than the supply cord
already fitted to the appliance.
4. Check the supply and any extension cord regularly for damage or signs of
ageing. Do not use the appliance, if the cords are damaged.
5. When servicing the cutting means be aware that, even though the motor will
not start due to the interlock feature of the guard, the cutting means can still be
moved if the motor is turned by hand.
6. Never attempt to override the interlock feature of the guarding.
7. Remove deposited matter from the machine using a brush.
8. Always clean the machine after use. Clean the plastic body and plastic parts
using soap and a moist cloth. Do not use aggressive agents or solvents for
cleaning.
9. Never clean the shredder with a jet of water or by rinsing. Make sure that no
water is allowed to enter into the shredder.
10. Use only the recommended accessories and attachment for this shredder.
Determine the maximum permissible system impedance Zmax( 0.3 24Ω)
NOTE:
at the interface point of the user's supply ,declare Zmax( 0.3 24Ω) in the equipment
instruction manual and instruct the user to determine in consultation with the supply
authority, if necessary, that the equipment is connected only to a supply of that
impedance or les s.
Werbung
