Caretero EGIS Bedienungsanleitung Seite 20

INSTALLATION OF THE SEAT IN GROUP II (15-25 kg)
6
To install the seat in group II, remove the 5-point belts from the seat - the instructions for loosening the belts are
shown in chapter 10, points
Adjust the height of the headrest (B-1) by grabbing the seat with one hand and the headrest height adjuster with the
other. After pressing the adjustment, move the headrest to a height that allows the child to travel comfortably in the
seat. Place the car seat on a forward-facing car seat in a seat equipped with a 3-point car seat belt. Push the car
seat against the backrest of the car (B-2). Place the child in the seat (B-3). Fasten the child with the 3-point car
belts, threading the belt through the guides as shown in the picture (B-4). Tighten the belt so that it is tight (B-5).
Make sure that the car seat is snug against the backrest of the car seat and that the belts are properly tightened and
not twisted.
7 INSTALLATION OF THE SEAT IN GROUP III (22-36 kg)
To install the seat in group II, remove the 5-point belts from the seat - the instructions for loosening the belts are
shown in chapter 11, point G-1.
Grasp the backrest with one hand and the seat with the other (C-1). Tilt the seat back so that it disengages from the
seat (C-2) Place the seat of the car seat on the seat of the car equipped with 3-point belts (C-3). Place the child in
the seat (C-4). Fasten the child with the 3-point car belts, threading the belt through the guides as shown in the figure
(C-5). Tighten the belt so that it is tight (C-6). Make sure that the car seat is snug against the backrest of the car seat
and that the belts are properly tightened and not twisted.
8 ADJUSTING THE 5-POINT HARNESS
Loosen the shoulder straps by pressing the button on the front of the seat and pulling both shoulder straps at the
same time (D-1). Turn the seat over, disconnect the connector of the chest strapsRemove the straps from the
connector at the bottom of the seat (D-3). Remove the belts by pulling them at the front of the backrest. Adjust the
height of the headrest and then thread the straps through the holes that match the height of the child's shoulders
(D-4). Insert the straps into the connector at the bottom of the base at the back of the seat and then connect them
with the connector on the chest strap (D-5). Tighten the straps using the strap protruding from the front of the seat
base.
9 HEADREST HEIGHT ADJUSTMENT
Adjust the height of the headrest by grabbing the seat with one hand and the headrest height adjuster with the other.
After pressing the adjustment, move the headrest to a height that allows the child to travel comfortably in the seat
(E-1).
10 REMOVING THE 5-POINT BELTS
Loosen the shoulder straps by pressing the button on the front of the seat and pulling both shoulder straps at the
same time (F-1). Turn the seat over, disconnect the connector of the chest straps (F-2). Remove the straps from the
connector at the bottom of the seat (F-3, F-4). Remove the belts by pulling them at the front of the backrest. Turn the
seat so that you can see its base. Twist the 3 clips on the ends of the belts in your fingers, thread them through the
holes from which the belts protrude and pull them out from the top of the seat (F-5). To reinstall the belts, perform all
the steps in reverse order.
11 CONNECTING THE BACKREST TO THE BASE OF THE SEAT
Align the seat backrest and the base so that the joints overlap like a hinge (G-1). Tilt the backrest so that it connects
to the base (G-2).
12 FASTENING THE 5-POINT HARNESS
Connect the parts of the buckle on the shoulder straps (H-1). Clip both parts into the buckle located on the hip belt
of the seat (H-2). Make sure the belts are tight (H-3).
To loosen the straps, use the button on the front of the seat, then pull both shoulder straps (I-1).
To tighten the belts, pull the end of the belt protruding next to the belt release button (I-2).
19
to
F-1 F-5.