eta GENSI Bedienungsanleitung Seite 15

With the help of a high-frequency ultrasonic oscillator, the aroma diffuser creates
microscopic droplets with a diameter of approx. 1–5 μm from water and essential oil.
The droplets are then blown out into the air in the room through the ventilation system
in the form of cold steam (water spray) which is then evaporated, thus releasing
ON/OFF button + steam generation (A1)
1. First pressing – switching on maximum steam volume
2. Second pressing – switching on low steam volume
3. Third pressing – switching off the device (no generation of steam)
Colour illumination button (A2)
1. First pressing – changing colour illumination is on
2. Second pressing – single-colour illumination is on (continuous light of the colour at the
3. Third pressing – colour illumination is off
Aroma diffusor also allows sole colour illumination (i.e. without steam generation).
INSTRUCTIONS FOR USE (Fig. 2)
1. Place the appliance on a suitable flat surface.
2. Remove water tank A3 from the base A, fill in cold drinking water. You can add a few drops
(about 1 – 2 drops) of natural essential oil into the water. Install the tank back on the base.
3. Plug the device in by means of B adapter (sound signal will be generated and light
illumination will flash once).
4. Set relevant operation mode using buttons A1 and A2.
5. When the tank is empty, the device is automatically switched off.
6. After use, unplug the device.
– The aroma diffuser can be used in combination with natural essential oils or on its
own with water as a humidifier.
– For using and dosage of essential oils, please follow the manufacturer´s instructions.
– The maximum tank capacity (2 l) will deliver up to approx. 16 hours of operation.
IV. MAINTENANCE
Clean the appliance and adapter, tank A3 and cover A6 with a wet cloth. You may also use
disinfectants but always follow the instructions provided on the packaging. Clean the ultrasound
converter with a cloth (sponge) and warm soapy water. For scale removal, use tepid solution with
citric acid or vinegar. Be aware of the fact that a contaminated ultrasound converter will not
function properly! Never use aggressive detergents (e.g. petrol, glass cleaner, furniture
polish, thinner) or other solvents to clean the appliance! After maintenance, let the individual
parts dry properly. Never use sources of heat to dry the plastic parts (such as oven, electric or gas
stove).
More extensive maintenance or maintenance requiring intervention in the inner parts
of the appliance must be carried out by professional service! Failure to comply with the
instructions of the manufacturer will lead to expiration of the right to guarantee repair!
V. ENVIRONMENT
If the dimensions allow, there are marks of materials used for production of packing,
components and accessories as well as their recycling on all parts.
aromatic essences and increasing air humidity.
moment when the button was pressed)
Note
Note
Notes
15 / 31
EN