Beurer EM 30 Gebrauchsanleitung Seite 11

Description of the display symbols
A Battery status display: flashes if the battery is flat
B Intensity:
C Pause symbol:
D Timer:
E Key:
F Program:
A B C
4. Operation
Inserting batteries
If the battery symbol in the display flashes, the batteries are flat and must be replaced. The opera-
ting unit must be removed from the holder on the belt to insert or replace batteries.
– Release the magnetic connector by pulling the device away from the belt.
The magnetic connector of the two contact buttons clicks out noticeably.
– Pull the device upwards out of the holder.
– Remove the battery compartment lid by pressing and sliding in the direction of the arrow.
– Insert the batteries observing the markings in the battery compartment. Ensure correct battery
polarity.
Note:
– Rechargeable batteries cannot be used for this device.
– If the device is not in use, we recommend keeping the device separate from the belt. If the
device is not needed for a long period, we recommend first removing the batteries.
– Used batteries do not belong in domestic garbage. You are legally obligated to
dispose of the batteries. Dispose of these through your electrical dealer or your
local recycling center.
– Batteries containing pollutants are marked with the following symbols:
Pb = battery contains lead,
Cd = battery contains cadmium,
Hg = battery contains mercury.
– Please dispose of the device in accordance with the directive
2002/96/EG – WEEE (Waste Electrical and Electronic Equipment). If you
have any queries, please refer to the local authorities responsible for
waste disposal.
Attaching the belt
Before each training session you should ensure that your skin is clean and free of creams or oils.
Only then can the device work optimally.
– Lay the belt down with the electrodes facing towards you.
– Moisten both electrodes and your stomach with water. Make sure the electrode surfaces are
evenly moistened to avoid high voltage points on your skin during subsequent training.
– Place the belt around your waist so that the electrodes are positioned on your stomach. Then
close the Velcro fastener.
The belt is made of an elastic material and fits a wide range of waist sizes. Take care that it is tight
enough for good contact between the electrode and skin, but does not constrict you.
All manuals and user guides at all-guides.com
set intensity levels 0 - 40
flashes if pause is activated
remaining time for the program started
key lock is activated
selected program with the number of training cycles already
completed
D E F
11
Pb Cd Hg