Werbung
Wichtige Hinweise Sicherheitsregeln für die Aufstellung
Important and practical information
Avis importants et practiques
Prior to mounting the META shelves it is absolutely necessary to read the information
contained in these instructions as well as the "safety regulations" at the end of them.
Please follow exactly these instructions, as well as the information contained in our
commission papers and the advice of our qualified staff. Also take notice of the gene-
ral accident prevention regulations of the trade and craft associations and the general
regulations of the authorities supervising the enforcement of laws governing health and
safety conditions of work. The parts of the shelves delivered by META must be moun-
ted according to their special application only. META does not take any responsibility
for incorrect handling, usage or mounting. The conditions for usage and load-bearing
capacity can change when the shelves are remounted in a different place. In such
cases please consult a META specialist in order to avoid damage. There should always
be at least two persons mounting the shelves. A low table or two separate bucks could
be very helpful to place the individual part while pre-mounting the shelves. When the
frame is mounted, please pay attention to the direction of the profile holes on the front
side. While mounting the individual parts, do not use force, e.g. a metal hammer or
metal bars. Only use a rubber hammer or a soft intermediate wooden layer. In order to
avoid turning over, please secure all shelves with a ratio height - depth of more than
5:1. This can be reached by floor pegging. The foundation bolts in our catalogue are
dimensioned so that one dowel should be used per bottom plate. All shelves must be
pegged regardless of their ratio height - depth, if extendible parts or wing doors are
mounted to them (i.e. drawers, extendible registers etc.)
Stand 02/2005
8
Das Lagersystem
Werbung
