VITRA V-Care Prime Bedienungsanleitung Seite 46

Basic maintenance
How to clean the main unit
- You may also call on you service provider to change the tip of the nozzle when
you feel necessary."
Soak a soft cloth in water and squeeze the cloth hard
1
to rid of excessive water.
Clean dirty areas by putting small amount of neutral
2
detergent on the cloth and wiping the area.
Polish the cleaned area with separate dry cloth to
3
finish.
Remember the following when cleaning V-Care Prime.
!
a. Do not use acid or alkaline detergents as this could
cause rust on the metal parts.
b. Toilet detergents can damage the plastic part of the
product because of the volatile gas in the substance.
When cleaning with toilet detergents, finish cleaning
quickly and keep the seat cover open after cleaning.
c. Make sure that the toilet detergent does not get on
the plastic part of the product.
1
Press rear washing and female washing together for
seconds to eject the nozzle for manual cleaning.
2 Wipe the nozzle softly using a soft cloth.
• Be careful not to damage the nozzle hole.
• Do not use cloths with rough surface.
• Open the seat and toilet cover.
• Hold the nozzle lightly when cleaning.
3
Press stop button on the remote control to return the
nozzle to its original position.
If stop button is not pressed, the nozzle goes back to it
original position 3 minutes after it is ejected.
45
EN
3