Plug The Device Into Power Outlet; Raid Mode Setting And Connection; Raid Modes & Dip Switch - Ugreen Cm335 Bedienungsanleitung

4 Plug The Device Into Power Outlet

1. Connect the enclosure to your PC / laptop via the provided cable, then connect to the power adapter.
2. Power on the device, the power indicator turns solid white.
Warning
Non-standard or non-certified adapters are not allowed in case of the potential risks.
IV RAID Mode Setting and Connection
1 RAID Modes & DIP Switch
DIP Switch Status
RAID DIP
Modes Switch
1
RAID 0
ON
(Fast Mode)
RAID 1
OFF
(Safe Mode)
SPAN
ON
OFF
PM
Min. Drive Available
Number Capacity
2
Total hard drive
OFF 2
capacities
Min. hard drive
ON 2
capacity
Total hard drive
ON 2
capacities
Total hard drive
1
capacities
OFF
Supplied Accessory
Supplied Accessory
Fastest read and write mode, largest capacity but low security.
When one of the hard drives fails, all of the data cannot be restored.
High security, acceptable read and write with small capacity.
When one hard drive fails, other drives work normally; then you'll
have to replace the broken drive (greater than or equal to the
capacity of the original capacity), all of your lost data will be
recovered automatically.
Largest available capacity, average read and write speed, and
low security.
All hard drives form a big drive, when one of them fails, all of your
data will be unrecoverable.
Default factory setting mode, all disks work separately.
When one disk fails, all the others will not be affected.
7
Description