Njoy Renton 650 USB Bedienungsanleitung Seite 3

3 Installation
The UPS can protect your equipment from all power
problems such as surge, spikes, blackouts, brownouts
and line noise. When AC power is present and the ON/
OFF switch is turned ON, the UPS is always charging
the battery and provides power to the equipment from
AC line directly. A reliable built-in battery can provide
stable power in order for you to complete your work,
save your data and safely shut down your system when
there is a utility power blackout.
Connecting your equipment and first usage
3.1
The UPS is simple to operate and install. Please read
the following steps before connecting any equipments
to this UPS:
Step 1. Connect the UPS to a grounded AC power
outlets.
Step 2. Please turn ON the ON/OFF switch and charge
the battery at least 8 hours for a full load
before you start to use the UPS.
Step 3. Plug your PC or peripheral equipment (printer,
TV, scanner, fax, speakers etc.) into the power
outlets of the UPS (these will provide emergency
battery backup power during mains blackouts as
well as surge protection from surges and spikes).
04
CAUTION
Do NOT plug
LASER PRINTERS
into any of the
outlets.
Indicators & Alarm Table for Operation
3.2
Visual
Conditions
Indicator
Normal On
Utility Failure - The
UPS is providing battery Flash
power to outlets.
Utility Failure - The
UPS is providing battery
power. The rapid beeping Flash
indicate the battery will
run out of power shortly.
Overload - Occurs when
connected equipment
exceeds the rating of the
unit. Turn the UPS off On/Flash
and unplug at least one
piece of equipment from
the UPS.
Do NOT plug any
SURGE STRIPS
into any of the
outlets.
Alarm
Off
Beep 1 time In
Every 30 Seconds
Beep 1 time In
Every 2 Seconds
Beep 1 time In
Every 0.5 Second
05