Würth WPS 12-700 Originalbetriebsanleitung Seite 17

Display Status Meaning
is lit red The charger is not properly
flashes
red
is lit
yellow
is lit
green
▸
Plug the charger plug in the connector [10] at the
side of the device.
▸
Check if the voltage applied to the AC outlet volt-
age matches the input voltage of the charger.
▸
Plug the charger plug in a wall socket.
During charging, the yellow LED lights
up. Once the charging process is
completed, the green LED lights up. A
complete charging process can last up to
72 hours.
▸
After charging, disconnect the charger from the
alternating current source.
▸
Disconnect all connections between the charger
and the Power Start.
connected to the device, the
charging will not start.
The charging process can not
be completed normally and
will be aborted.
▸
To reset the device after
an aborted charging, dis-
connect the charger from
the power outlet for a few
seconds.
The device is being charged.
The device is fully charged
and the charger is in the trickle
mode, this means, the full
charge of the battery is main-
tained without damaging it.
Check charging state
Attention !
Only use the device only in a fully charged state
¾
▸
Ensure that the operating switch [3] is set to "0"
and that the device is not connected to the vehicle
battery.
▸
Press the charging state button [7].
The charging state of the device is indicated on
3
the display [6] in percent.
Upon switching on the operating switch
[3], the voltage of the internal battery is
shown in volt.
Vehicle battery voltage
If the Power Start is connected to a vehicle and
3
the operating switch [3] is set to "0", then the ve-
hicle battery voltage is shown on the display [6].
If the Power Start is connected to a vehicle and
3
switched on, then the average voltage between
the vehicle battery and the internal battery of the
Power Start is shown on the display [6].
The battery charge state is displayed
most accurately when the Power Start
was disconnected from any external
devices and charging sources for several
hours.
17