Installation Instruction - Wellis Ditte WF00032 Montageanleitung

1. Installation Notice:
EN
1. Water must be turned off at main supply before you begin installation
2. Never use cement or plaster to fix or seal the water closet on the floor because rigid
materials used can expand while hardening and may cause ceramic to break.
3. Do not over tighten closet nuts as you may crack the base of the toilet and bolt caps
may pop off.
4. Do not over tighten the toilet fill valve water supply nut, this way may cause leakage.
2. Tools (not included)
Flat Screwdriver
Spanner

3. Installation Instruction

3-1 Install the Seat cover onto the Toilet Pan following the seat cover installation manual
which included in the seat covers you have received.
4-2 Install the fittings into the Cistern.
4-2-1 Water Filling valve installation
Drilling machine
Spirit level
1) Unscrew the lock nut from the thread of
water inlet valve.
2) Insert the water inlet valve with rubber
seal washer into the toilet side inlet hole
vertically and assure the rubber seal wash-
er is attached to the tank surface; then nest
the plastic seal washer and hexagon lock
nut into the water inlet valve connector
from outer tank.
3) Tighten the hexagon lock nut subject
to no interference among the tank and
fittings. Turn on water to clean the water
supply pipe and connect the water supply
pipe with the valve.
Silica gel
Tape measure Pencil