Instructions For Use; Adjusting The Auxiliary Handle - Tyrolit DHE32 Betriebsanleitung

Instructions for use

Before switching on the power tool
Unpack the power tool and accessories and
check that no parts are missing or
damaged.

Adjusting the auxiliary handle

WARNING!
Before performing any work on the power
tool, pull out the mains plug.
CAUTION!
Use the power tool with the attached
auxiliary handle only.
The auxiliary handle can be swivelled into
any position to ensure safe and fatigue-free
working.
 Release the clamping by turning the
auxiliary handle counterclockwise (1.).
 Swivel the auxiliary handle into the
desired position (2.).
 Secure the adjustment by turning the
auxiliary handle clockwise.
Attaching the depth stop
WARNING!
Before performing any work on the power
tool, pull out the mains plug.
20
 Press and hold clamping lever on the
auxiliary handle in the upper area.
 Push in depth stop.
 Set depth stop to the required drilling
depth.
 Release clamping lever.
Inserting tools with SDS shank
WARNING!
Before performing any work on the power
tool, pull out the mains plug.
CAUTION!
Used cutting accessories may become hot.
Wear protective gloves!
NOTE!
Tools used must have an SDS shank.
If tools do not have an SDS shank
(e.g. wood drill bit), a three-jaw chuck must
be used (see "Setting the operating mode").
 Check the dust cap.
– Clean the cap if dirty.
– Have a defective dust cap replaced.
 Clean tools and lightly grease the shank.
TYROLIT
DHE32