End Of Program - Beko DS 7335 PX0 Bedienungsanleitung

Operating the product
5.11 Changing the program
after it is started
You can change the program you selected
to dry your laundry with a different program
after the machine starts running.
• For example, to select Extra Dry instead
of Iron Dry, pause the program by
pressing the Start / Stand-by button.
• Select the Extra Dry program using the
Program Selection button.
• Press the Start/Stand-by button to start
the program.
Adding and removing clothes during
stand-by
• If you want to add or remove clothes
to/from the machine after the drying
program starts:
• Press the Start/Stand-by button to put
the machine in Stand-by state. The
drying operation stops.
• Open the loading door while in Stand-
by state, and close the door after you
remove or add laundry.
• Press the Start/Stand-by button to start
the program.
C
Adding laundry after the drying
operation starts may cause the
dried laundry inside the machine
to mix with wet laundry and leave
the laundry damp at the end of
operation.
C
Adding or removing laundry
during drying may be repeated as
many times as you wish. But this
operation continuously interrupts
the drying operation, and thus
increases program duration and
energy consumption. So, it is
recommended to add laundry
before the program starts.
C
If a new program is selected by
turning the program selection
knob while the machine is in
stand-by; the running program
terminates and new program
information is displayed on the
screen.
56 / EN
WARNING: Do not touch the
inner surface of the drum while
adding or removing clothes during
a continuing program. The drum
surface is hot.
5.12 Cancelling the program
If you want to cancel the program and
terminate the drying operation for any
reason after the machine starts running,
keep the On/Off/Cancel button pressed for
3 seconds.
A
WARNING: The inside of the
machine shall be extremely hot
when you cancel the program
during machine operation, so run
the ventilation program to allow it
to cool down.

5.13 End of program

When the program ends, the Fibre Filter
Cleaning and Water Tank warning symbols on
the program observation indicator turn on.
Loading door may be opened and machine
becomes ready for another run.
To turn off the machine, press the On/Off/
Cancel button.
C
Wrinkle Prevention function
activates the 2 hour-Wrinkle
Prevention program if laundry
isn't taken out of machine after
completion of the program.
C
Clean the fibre filter after each
drying. See 6.1 Cleaning Lint Filter
/ Loading Door Inner Surface
C
Empty the water tank after each
drying. See 6.3 Draining the water
tank
Dryer / User Manual