Cleaning And Maintenance - Adler europe AD 7050 Bedienungsanweisung

A7 - Rectangular brush – For cleaning small surfaces.
A8 - Round brush - For cleaning small surfaces.
A9 - Pointy nozzle – For softening grime and removing dirt with more pressure.
A10 - Cup – For filling the water container.

CLEANING AND MAINTENANCE

NOTE: Before cleaning, please make sure the product has been turned off and unplugged from the power supply. Also, make sure that the
product and components/accessories have cooled down.
Step 1: After using the product, the remaining water in the water container must be poured from the device and left to air-dry, to avoid the
lime creating inside of the water container.
Step 2: Do not use hard or sharp objects to clean the product or other components to avoid damage.
Step 3: Take the cloth and use a mild cleaning agent to thoroughly clean the cloth. Let it air-dry thoroughly before further use or storage.
Step 5: Use a soft wet cloth to clean the machine body, the nozzle, and all other accessories. Then use a dry soft cloth to wipe dry the
product.
Step 4: Put the product and the accessories in a dry and cool place out of reach of children or animals.
Step 5: If the product is not used for a prolonged period of time, you may disassemble the product.
NOTES:
After the cooling of the product, hot steam will become water vapor after cooling. Some water vapor will accumulate in the steam nozzle
and become water drops, which is a normal phenomenon – so make sure to let it dry completely.
Cleaning cloths can be machine washed at low temperatures ( Up to 30 C).
Do not put cleaning cloths into an electric dryer. Air-dry it.
The cleaning cloth is a consumable item. Please replace with new cleaning cloth when appropriate. Not doing so will affect the device's
efficiency.
If the cleaning cloth begins to unravel, please cut the loose threads carefully and do not pull on them.
If the product become blocked by limescale, mix one part of citric acid with three parts water. Pour this mixture into the water container
and leave it for 6 hours. After that, turn the device ON over a non-citric acid/water-resistant surface.
TROUBLESHOOTING
If there is a problem with your product, check the following details before requesting service
to your dealer.
Issue:
No steam
Possible Solution:
Check if the device is connected to the power supply.
Check if the power button and steam switch are in the ON position
Check the water level.
Issue:
Not working
Possible Solution:
Check if the device's power button is turned on and the cable is connected to the power supply.
Issue:
The product become blocked by limescale
Possible Solution:
Mix one part of citric acid with three parts of water. Pour this mixture into the water container and leave it for 6 hours. After, turn the device
ON over a non-citric acid/water resistant surface.
Technical Data:
Power Supply: 220-240V ~ 50/60 Hz
Power: 1200 W
Water container capacity: 120 ml
Steam output rate: ~ 22 ml / min
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste
bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may
effect the environment. Do not dispose this appliance in the common waste bin.
6