xjump XJ 200 Bedienungsanleitung Seite 17

TWS PAIRING METHODS
Two device of this model could connect together by this button
1. Prepare two device which is disconnected with any other buetooth device;
2. Single clik this button
3. After a while, you will hear a long sound "di ~" , it means this two device connected sucessfully;
4. Under connection, on your mobile device, search Bluetooth device and select "XJ 200" .
Note: Using the TWS function must get the two device paired at first then continuing the Bluetooth
function.
MICRO SD CARD/USB OPERATION
1. Turn on the speaker;
2. Insert a micro SD card into the slot (9) holding the contacts facing upwards;
3. Playback will start automatically;
4. Press and hold the key
button for a few seconds to go to the previous song;
5. Press the button
AUX IN
1. Connect the Jack/Jack audio cable (NOT supplied) to the AUX jack (8) and the other end to
the external device. The device will automatically go to AUX mode;
2. Start from the external device playback.
(5) of them, you will hear short "di" sound after you single click;
(7) for a few seconds to go to the next song, press and hold
(3) to pause, press it again to resume
(5) to boom up the music.
playback.
English
(1)
17