Hama 00223352 Bedienungsanleitung Seite 2

G Operating instruction
1. Explanation of Warning Symbols and Notes
Risk of electric shock
This symbol indicates product parts energized
with a dangerous voltage of su cient magnitude
to constitute a risk of electric shock.
Warning
This symbol is used to indicate safety instructions
or to draw your attention to speci c hazards
and risks.
Note
This symbol is used to indicate additional
information or important notes.
2. Package Contents
• USB vehicle charger
• These operating instructions
3. Safety Notes
• When using this product, observe the applicable
local tra c laws and regulations.
• Take care that components such as airbags, safety
areas, controls, instruments, etc. and visibility are
not blocked or restricted.
• Do not allow yourself to be distracted by the
product when driving a vehicle. Always pay
attention to the surrounding tra c and your
environment.
• Protect the product from dirt, moisture and
overheating, and only use it in a dry environment.
• Do not drop the product and do not expose it to
any major shocks.
• Do not operate the product outside the power
limits given in the speci cations.
• Do not modify the device in any way. Doing so
voids the warranty.
• Do not continue to operate the device if it
becomes visibly damaged.
• Use the product for its intended purpose only.
• Keep this product, as all electrical products, out of
the reach of children!
• Do not bend or crush the cable.
• Always pull directly on the plug when
disconnecting the cable, never on the cable itself.
• Do not use the product in the immediate vicinity
of heaters or other heat sources or in direct
sunlight.
• Dispose of packaging material immediately
according to locally applicable regulations.
2
Risk of electric shock
• Do not open the device or continue to operate
it if it becomes damaged.
• Do not use the product if the charging cable,
adapter cable or power cable is damaged.
• Do not attempt to service or repair the product
yourself. Leave any and all service work to
quali ed experts.
4. Operation
Note – mains voltage 12 – 24 V
Only operate the power supply unit on car
electrical networks with a network voltage of
12 – 24 V.
Warning – Connecting terminal
devices
• Before connecting a terminal device, check
whether the power output of the charger can
supply su cient power for the device.
• Ensure that the power of the connected
terminal device does not exceed 22 W.
• Please refer to the instructions in the operating
manual of your terminal device.
Unless the operating instructions for the devices
you want to charge explicitly inform you otherwise,
proceed as follows:
• Connect your terminal device to a USB charging
socket using a suitable USB cable.
• Connect the charger to the car socket of the
vehicle electrical system.
• Charging progress is displayed on your terminal
device.
• Disconnect the terminal device from the charger if
you want to interrupt charging or if the terminal
device is fully charged.
• Then disconnect the charger from the power
supply.
When charging batteries built into a device, pay
attention to the maximum charging time for the
batteries.
Note – Car battery
With some vehicles, it can happen that power
continues to be supplied even though the ignition
has been switched off. Therefore, when not using
the product, disconnect it from the power supply
to protect your car battery from discharge.