Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting Guide - Maytronics Dolphin WAVE 80 Bedienungsanweisungen

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 31
7

Troubleshooting Guide

Before contacting your Robot Pool Cleaner distributor please read through this guide.
The pool water condition must be within the following parameters:
PH: 7.0 – 7.8
Temperature: 6˚C(43˚F) to 34˚C(93˚F)
Symptom
Cable twisting or cable coils up
Robot pool cleaner is moving in circles or does not reach all pool
areas
Robot pool cleaner is not traveling sideways on walls
Robot pool cleaner does not climb walls
Robot pool cleaner not sinking
Robot pool cleaner disengaging from wall at water line
RCU is not working
Motor is not working
NaCl: Max 5,000 ppm
Chlorine: Max 4 ppm
Solution
Check for any obstruction in the pool
Remove excess cable from the pool
Make sure filter cartridge is clean
Straighten cable and lay it in the sun periodically
Check for foreign objects in moving parts
Make sure filter elements are clean and that the filter
doors are closed
Make sure that there is enough cable laid out to cover the
whole pool
Before using the robot pool cleaner at the beginning
of the season you should brush any algae from the floor
and walls of the pool
Adjust the diagonal angle of the handle
Make sure the filter cartridge is clean
If using the robot pool cleaner at the beginning of the season,
use the Spring cartridge
If using the robot pool cleaner at the beginning
of the season you should first brush any algae from the floor
and walls of the pool
Check if brushes are suitable for pool coating and replace
them if necessary
Check if brushes are worn and replace them if necessary
Make sure the Impeller area is clean
Check that the RCU is set for climbing
Make sure the Wonder brushes or the combined
brushes are soaked in water
If robot pool cleaner climbs too high consult your
robot pool cleaner distributor
Check if the batteries need replacing
Check if the impeller is blocked
Check if the drive system is blocked
Electrical problem (power supply), check power source.
If power source is in order, please contact your
robot pool cleaner distributor
English

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis