Products; Mounting Instructions - CombiSteel 7178.3205 Betriebs- Und Wartungsanleitung

CODE
7178.0100 Electric bain marie, tabletop model
7178.0535 Electric bain maire on closed cabinet
7178.0295 Electric bain marie, tabletop model, GN 1/2 + GN 1/3 h=150 mm
7178.3205 Electric bain maire on closed cabinet
Placement
 Installation and adjustment of the device should be carried out by experienced technical
staff.
 In order to prevent smell and fume formation, place the device beneath an exhaust hood
being capable of enough ventilation.
 Place the device at a place min. 10cm away from the side or back wall to prevent excessive
temperature rises.
 Device should be placed on a flat surface by suitably balancing on the four adjustable legs
(Figure A).
 Remove the protective nylon on the device. Clean the adhesive particles left on the device
with a suitable cleaner.
 Never leave flammable material near the device.
Electrical Connection
 Connect the device to the electrical installation according to the electrical standards of
the relevant country.
 Feed the device with suitable network voltage written on the information plate.
 Connect to the electrical installation over a suitable automatic fuse. Fix the said fuse on a
place that is easily accessible in case of a danger.
 The cable connecting the device to the electrical installation should be at least type H05
RNF.
 Before connecting the electrical inlet cable to the inlet clamp on the device, connect the
cable by passing it through the inlet coupling. And then tighten the coupling cover in a
manner that does not allow cable return.
 Electrical inlet is indicated with a label on the device.
 Voltage tolerance should not exceed ± 10%.
 If the device will be used in a commercial kitchen, apply a correct grounding system.
Here, consider DIN VDE D100 Article 540.
 Grounding screw "
B. PRODUCTS
C. MOUNTING INSTRUCTION
" is indicated with a label behind the device
DESCRIPTION
5
SERIE
600
700
700-S
900