Know Your Product - Status Cbl20-2Li Originalbetriebsanleitung

KNOW YOUR PRODUCT

OPERATION
• To use this tool properly, you must observe the safety regulations, the assembly
instructions and the operating instructions to be found in this Manual. All persons
who use and service the machine have to be acquainted with this Manual and must be
informed about its potential hazards. Children and frail people must not use this tool.
Children should be supervised at all times if they are in the area in which the tool is
being used. It is also imperative that you observe the accident prevention regulations
in force in your area. The same applies for general rules of occupational health and
safety.
• The manufacturer shall not be liable for any changes made to the tool nor for any
damage resulting from such changes.
Even when the tool is used as prescribed it is not possible to eliminate all residual risk
factors. The following hazards may arise in connection with the tool's construction and
design:
• Damage to the lungs if an effective dust mask is not worn.
• Damage to hearing if effective ear defenders are notworn.
• Power tools must not be used outdoors in rainy weather, or in moist environment (after
rain) or in close vicinity with easily flammable liquids and gases. The working place
should be well lit.
KNOW YOUR PRODUCT
1. Keyless chuck
2. Speed selector switch
3. Forward/reverse switch
4. Battery release button
5. Battery
6. ON/OFF trigger switch
OPERATION
CHARGING BATTERY PACK (Fig. 3)
Ligts
Red off, Green on
Red on, Green off
Red off, Green flashing
Red flashing, Green off
FITTING AND REMOVING THEBATTERY PACK
To remove the battery: Press release button (4) in the indicated direction (A) and pull the
battery out of the machine body. (B)
EN
7. Battery state indicator
8. LED light
9. Torque adjustment collar
10. Charger
11. Battery state check button
Status
Plugged in / Fully charged
Charging in progress
Battery is overheated
Battery is defected
6